- The caliper supports arrived very quickly all the way from Japan and the parts are of very high quality and fit perfectly. I will be fitting them to my UK 1980 Yamaha RD350LC (4L0) (also known as RZ35...자세히보기
- I bought this because I went with brembo.Of course, Exactly is attached, but you need to adjust the Shim to get Center.자세히보기
- This is a must have part for brembo installation.I was not sure if it was Radial Mount or Axial Mount, but Axial is enough because it is OverQuality.To install, just mount it on the Front fork and ass...자세히보기
- I used it in the field where I put brembo4POD on VT250 SPADA.The one I received is the one with no problems.The BoltQuantity is included with the Caliper.:There are 2pc.Be sure to check the fastenedTo...자세히보기
- [How is it used?Used in the OEMRotor300 era.Silver, Compact and thick.I didn't feel rigid anxiety.Although the hole dimensions are provided, installation should be done with the Caliper on the side th...자세히보기
- It purchased, in order to attach a Brembo caliper to VTR-F.
Although the Support of the Active was also good, since it seemed that there was only a PLOT, the object for one side was decided to be thi...자세히보기 - I think that the form which is necessaries in SRX at Brembo-caliper wearing and which can attach a Caliper to the position if it may be allowed to wish so much nearer to a Front CB400T is lighter, and...자세히보기
- Nisshin 6POT and a brembo Casting -- although it worried about which it will be made, since the new article of the brembo was obtained at a low price, the Caliper support was purchased inevitably.
As...자세히보기
일본
최대 쇼핑몰
전용 쿠폰,
세일
빠르고, 안정적인
배송