- 적합:
- YAMAHA SR500
- YAMAHA SR400
I bought it because I needed to replace the gasket when I overhauled the Manifold area.The paper quality is not bad and can be used just like OEM.good point● Easier to obtain than OEM.Durability is al...자세히보기 - 적합:
- YAMAHA
The manufacturer's Negative Pressure Adapter to this product The installation is very easy because of the Bolt On However, when 1 pc of an attached bolt is tightened about halfway, it suddenly becomes...자세히보기 - 적합:
- YAMAHA SR
I bought this product because the Idle Screw of the FCR Carburetor Body is difficult to useIt is easy to install and securely attached to the carburetorHowever, the Screw and the bottom screw of the F...자세히보기 - 적합:
- YAMAHA SR400
- YAMAHA SR500
If you use the FCR Carburetor Body Carburetor as you bought it You can install the throttle wire and remove it by simply removing the lock nut You canWhen working on setting up Carburetor, the frequen...자세히보기 - 적합:
- YAMAHA
I use the Assist system of Parts from Boa Ace's Parts, and to be honest, it works (Change) It seems that some of them have and some of them are getting worse One of the obvious changes is this Intake ...자세히보기 - 적합:
- YAMAHA SR
Thanks to this product, I was able to install the CR without any troubleThe Instruction Manual is also very helpfulI use it with a negative pressure adapter and there is no problem at all자세히보기 - 적합:
- YAMAHA SR
I bought it to install CR 38 of WM.I am satisfied that carburetor can be exchanged cleanly without interfering with FrameHowever, even if O-ring that sandwiches Manifold and Flange is too fat or Bolt ...자세히보기 - 적합:
- YAMAHA SR
If there is enough skill to remove Normal cab, it will easily take youNegative pressure is explained to be connected to Fuel Cock, but I dared to connect to Air inductorSince there is no choice, Fuel ...자세히보기 - 적합:
- YAMAHA
- YAMAHA
Until just before installation, there was a doubt - - -I was betrayed in a good way.Torque up. definitely.After all, Manufacturer doing seriously is different ~Number of boa Ace products handledI want...자세히보기 - 적합:
- YAMAHA
- YAMAHA
No one notices it, but I really like it.I did mirror surface processing myself.The mixture became thinner than originally, but the amount of air is increasing by that amount.You can blow better than t...자세히보기 - 적합:
- YAMAHA
- YAMAHA
If inclusion is satisfactory since the object for SR is foreseen and it is built, there are no worries about a Gasoline leak.
자세히보기 - 적합:
- YAMAHA
- YAMAHA
It is dramatically good. After exchange, since an air-fuel mixture becomes thin, change of setting is needed in the direction of deep Sakka. if setting is decided -- Power -- it can blow and stage fri...자세히보기 - 적합:
- YAMAHA
- YAMAHA
Parts that flow of the air-fuel mixture from a carburetor to an engine will be made into a smooth. It is the feature to carry out elliptic cutting of the admission port, and also it is aiming at the f...자세히보기
일본
최대 쇼핑몰
전용 쿠폰,
세일
빠르고, 안정적인
배송