BABYFACE

After installing the Babyface Rear Sets on the GSX-R1000R, I decided to install this as an optional part. It is a little cheaper, but I decided to use this one in order to have a sense of unity with t...

AGUSTA, but for the F4 series.Because Protection around Engine is weak.(Especially Right Side)In order to keep the damage to the standing moss to a minimum.I thought it was essential.I know Design is ...

The quality of the product was fine, as it is only a well-known PartsManufacturer.I bought it without hesitation because of its reasonable price.The installation was easy and only took a couple of min...

The Rear master cylinder's hose is extremely bent and difficult to install on the back and up of the Rear master cylinder.We are also missing 2 washer sheets, so we contacted UiBig & used the hellip;O...

Clutch cover type (Left Side)Installation is easy because all you have to do is remove the OEM plug and replace it.Wiring is carried out in the wiring hall, and Parenthesis is good in the race ish.The...

The installation of the screw has no space with a normal Spanner or Wrench, and cannot be tightened. It is forcibly turning by the hand and installing it, but after all it is the plan which buys a new...

It looks perfect.When I tighten with Tandem Footpeg, the hole position accuracy is too good, or it is off, or Bolt does not go into Smooth and hang.After installation, I tried to put the D Ring of the...

important item[Was there anything that disappointed you? The slide type lock makes it a little difficult to use as it is recessed in position.Do you have any wishes or improvements you would like to m...

There are a lot of Helmet locks that are attached to the back of the Tandem stay, but this one is attached to the front of the Tandem stay, so it is very useful.When I go on a long touring trip, I wea...

[Was there anything that disappointed you?We knew from looking at the product images that the Helmet was going to be difficult to installI have found the installation of the product to be very cautiou...

It is for 790DUKE, but can be installed on 890DUKER as it is.It is 890DUKER of the load capacity none, but because it comes to be able to hook NetCover with this, it comes to be able to load Small thi...

Motive for purchasingTriumph's R100 like the Daytona 675 and Street Triple I was told that the Shift spindleShaft of ROADSTERMODEL often breaks I was considering buying one because I had heard about i...

I heard the story that the Shift rod of DAYTONA 675 broke, and purchased as prevention.Babyface Rear Sets First. Since the outside is the fulcrum from the Shift rod, it feels easier to bear a burden t...

The trouble that Shift spindle Shaft breaks with the old and new of Daytona 675 was talked about at the 2 ton daytona thread, so it was installed as a measure.Whether Shaft's breaking effect is ef...

I will exchange it for Rear Sets of the company, so I installed it at the same time. So I do not understand the change so much. I think that the burden on Shift spindle will be reduced. Collar is diss...