H7 LED에 받기 쉽다는 것을 향상시킨 버전 등장!
팬과 시트 싱크가 일체화된 유닛을 LED밸브 후방에 나사들을 고정하는 사양입니다.
기존 H7은...
기존품은 팬 기반 → 히트 싱크 → 팬의 순서에 7-8개의 나사로 조립하며 차량에 장착하는 방식이었습니다.
이번 버전은...
노오멀 밸브를 비우고 LED밸브와 고무 캡을 설치하는 팬들을 체메입무만.
설치 시간이 대폭 단축됩니다!
플랜지부를 개량하고 90도마다 LED밸브의 삽입 각도를 선택할 수 있는 사양에 했습니다.
HONDA사의 Hi빔 등에 대응합니다.
차종에 맞추어 LED밸브의 길이가 조정할 수 있습니다.
LED밸브 후부는 분해하고 길이를 조정이 가능합니다.
중앙의 스페이서와 접시 나사를 뽑는 일로 6mm 짧게 할 수 있습니다.
The new version of H7 LED with improved ease of installation!
The integrated fan and seat sink unit is screwed into the back of the LED bulb.
Conventional H7 was
In the conventional product, the fan base, heat sink, and fan are assembled with 7-8 screws in this order and then installed in the vehicle.
This version is
Simply remove the stock bulb, install the LED bulb and rubber cap, and tighten the fan.
Installation time is greatly reduced!
The flange part has been improved to allow the LED bulb insertion angle to be selected in 90 degree increments.
Compatible with HONDA Hi-Beam and others.
The length of the LED bulb can be adjusted to fit your model.
The rear part of the LED bulb can be disassembled to adjust the length.
It can be shortened by 6mm by removing the center spacer and countersunk screw.