This is very light. The bolt head is made very beautiful but the thread is not beautiful because the surface is not flat. Because the bolt is made of titanium, it is not scratched when tightened with a socket
The material of this bolt is very light and hard compared to other bolts. But I'm not satisfied with finishing because some of the surfaces are not smoothView Detail
It is purchase for Brembo calipers. Although it is dramatically beautiful and there is also texture, the difference from a stainless Bolt is seldom felt.Is it self-satisfied? The Fork side of the picture is a Stainless bolt.View Detail
The material of this bolt is very light and hard compared to other bolts. But I'm not satisfied with finishing because some of the surfaces are not smoothView Detail
I bought it completely for appearance. I was a little bit uncomfortable with bremboOEM's Chromoly rusting. I can't tell any difference between the Fee Rings. I am not sure if there is any difference in the fee rings, but I am doing maintenance of the piston and oil seal together when I replace them. I tightened the Torque at 25N.m. I found the Titanium to be stiffer or tightly tightened compared to the Chromoly. Matte Black Caliper with Polished Titanium is a nice Parenthesis. The self-fulfillment level is moderately high for this product. The price of Bolt is very expensive, and for those who don't know, it may seem silly. It is a very expensive product for a Bolt, but I think it is satisfactory. It is probably the most expensive Bolt I have ever bought in my lifetime. There is also a Titaniumium Bolt for a slightly lower price, but I was excited because it is a security part.View Detail
I bought the Titaniumium Bolt for the first time because the OEM one was starting to show rust and corrosion. It is a bad Image because I can't feel the cost effect immediately, but I feel satisfied with it.View Detail
GSR400 (Gk7EA) Purchased for a 2010 Replacement is possible without any difficulty. Just by changing rusty OEM Bolt to Titanium, it will look better. But! The BridgeBolt was fine, but the Pat pin was not able to fit.:The 2pc did not work. It is necessary to pay attention to whether the person who considers the purchase fits Caliper of your vehicle. It is a product of about 15000 yen. 5 pieces each of One Side, Quantity of 10 pieces in total.:Since it is a Set, Quantity:For about 3,000 yen for 2pc, I became useless. The feeling of use is …I think that there is a thing that the Pin part has not been exchanged, but I was not able to understand it to myself of the amateur to say "HADRILL". But well, I think it is good because the appearance has been improved. It is expensive.View Detail
I installed it on the mikuni tm24 carburetor and placed it on the honda wave 125s. Piston of my bike has been upgraded from 52.5mm to 54mm. The results are unexpected, the carburetor adjustment is easy and smooth. Product parameters are very accurate.View Detail
I use it on honda wave125s (The brake pads of the wave125s are identical to the Grom) and i am very surprised about its performance. This type of brake pads are very well used in wet weather conditions and even in dry weather conditions. However, this will make the brake pad wear very quickly.View Detail
Tone torx socket is very useful to open the torx nut. Especially do not scratch the screw head and not be worn when opening the type of snailView Detail
The material of this bolt is very light and hard compared to other bolts. But I'm not satisfied with finishing because some of the surfaces are not smoothView Detail
This washer is very good. It is suitable in places where the thickness is low. Lightweight aluminum materials help to reduce weight rather than steel!View Detail
일본
최대 쇼핑몰
전용 쿠폰,
세일
빠르고, 안정적인
배송