I'd order DRC Motoled edge aluminum holder kit with smoke lens, the bracket is titanium color (not black color), but I like this color. I take about fifteen minutes to removethe original license plate holder and OEM blinker. I use the LED turn signal light oringinal on Triumph speed twin again, so I change, customize and replace the hole blinker bracket (include) with 10mm stanless steel hole blinker bracket. It took me 2 hours to reinstall, great results, look very nice, more modern and sporty. The photo attached to the review.
Fits: KAWASAKI D-TRACKER-X 08- KAWASAKI, KAWASAKI KLX250 08-
I bought it because I thought it was a Fender Eliminator first
Because the blinker bracket that came with it was a hole of M8, it was substituted with the Homsen bracket I did The shape is satisfactoryView Detail
Fits: KAWASAKI D-TRACKER-X 08- KAWASAKI, KAWASAKI KLX250 08-
Purchase to make Rear clean. Since OEMBlinker is not attached, replace with LED Blinker. Although attaching is easy, it is necessary to separately prepare the Coupler separately, although it is exclusively for the car model. It is good that it is attached to the Coupler.View Detail
Fits: KAWASAKI D-TRACKER-X 08- KAWASAKI, KAWASAKI KLX250 08-
When it had ridden for a while, some Lamps were lost in the point.Although I got the Manufacturer to exchange by
initial failure, since it is LED too, is it weak to vibration?
The second set is the vibrat
It attached to the KLX250 [ present ].
When it had ridden for a while, some Lamps were lost in the point.Although I got the Manufacturer to exchange by
initial failure, since it is LED too, is it weak to vibration?
The second set is the vibration proof measures about a feeling, and has inserted the Rubber board into the place where a car body and goods contact also at the contact part of a Lamp and a Stay.Even if it carries out to a mountain and adds an intense vibration for the moment [
], it is operating normal.
It becomes a racy Style and very pleasing.View Detail
Fits: KAWASAKI D-TRACKER-X 08- KAWASAKI, KAWASAKI KLX250 08-
IT was attached to D-TRACKER X (2012). Normal was the form which hung down greatly downward, when a road surface state was bad, it prevents the mud and water on which the tire bounded so that a following vehicle may not get dirty, but since appearance was surely not so good, I exchanged. Since exchange was only attached as the attached description, it was easy, but there was one point which worries. Although the harness side had attached wiring to the coupler, the general-purpose plug terminal was only attached to the aluminum holder kit side. Since it was a kit only for a vehicle type, if the coupler and terminal which are compatible with the harness side in wiring are attached, it was good. I cut wiring of the harness, and after I connected with the attached plug terminal, and protected with the autohesion tape.View Detail
Fits: KAWASAKI D-TRACKER-X 08- KAWASAKI, KAWASAKI KLX250 08-
However, if there is a wiring diagram, I will think that the combination of wiring by the side of a car body and a tail lamp was intelligible.
The pure fender of D trucker is huge,
There is fitting and it is the highest level also until it says no.
However, if there is a wiring diagram, I will think that the combination of wiring by the side of a car body and a tail lamp was intelligible.
The pure fender of D trucker is huge, and since it is [ the tail lamp ] the thickset, a direction to be renewed is recommended.View Detail
일본
최대 쇼핑몰
전용 쿠폰,
세일
빠르고, 안정적인
배송