About quality and textureAbout the feeling of useNice painted finish. Would have prefered satin black.About DesignFits around the Akrapovic headers nicely. A bit close on exit as pictured, the akra headers exit a bit higher, still 8mm gap. R77 slipon is clear of cowlAbout Size ChartThe right hand rear fixing nut needs grease on a ring spanner and long fingers.Cost performance and comparison with other productsSleek design, should cut through the air nicely.About shipping and packagingCame undamaged.Any concerns, cautions, or advice when purchasingScratches easily but to be expected.
I ordered it in a black gel coat finish which you would expect to arrive unblemished. When it arrived the black gel coat had been sanded through all around the edges exposing the fibreglass. One of the mounting points looks to have had an internal repair which has left a huge amount of resin built up around one side of the hole stopping you from being able to tighten the nut up squarely, if you tightened it it would break the mounting point. Required hours of messing about to make it fit nicely and then has to be painted. Wish I could post more than one photo. View Detail
순정 제품처럼 잘 맞고 멋집니다!우측부분 매니폴드에 살짝 간섭이 있기에 동봉된 와셔로 간격을 벌려줘야 하는 번거로움이 있는데 제작단계에서 이 부분을 보완해서 출고하면 더 좋을것 같습니다. 또한 도장면에 살짝 불량이 있었지만 해외구매라 교환이 번거로워 그냥 쓰려고 합니다.View Detail
Order the undercowl to paint it Matt black. Fit and finish is superb. All parts like nuts and bolts are there, even a manual how to mount. Fits perfect, looks perfect View Detail
카본 제품 구입하였고 혼자 장착하는데 무리 없었습니다. 카본 마감이나 장착은 딱 맞게 되어 있으나 매니폴더랑 간섭이 약간 있어 주행 중 타는 냄새가 납니다.카울을 약간은 갈아내야될거 같습니다.그 외에는 크게 불만은 없습니다. 향 후 다른 제품들도 구매 의향이 있습니다.----------------------------------------------------------I bought a carbon product and it was hard to install it alone. The carbon finish or mounting is perfect, but there are some manifolds and interference, which makes the smell of burning while driving. After flavoring, other products are also willing to buy.Powered by Google TranslatorView Detail
뒤까지 감싸주는 언더커버를 찾다가 디자인이 가장 마음에 들어서 구입하게된 상품입니다. 오버레이싱이나 매지컬레이싱,에이텍처럼 그동안 흔하게 들어본 브랜드가 아니라서 사실 구입을 약간 망설였던 부분도 있었지만 다행히도 결론은 대만족이네요.
순정의 배기관을 잘 감싸며 수제작의 카본재질 언더커버임에도 피팅이 문제없이 잘 됩니다. 차량의 상태의 따라 와셔로 어느정도 간격조절은 분명히 해야겠지만 장착하는데 큰 어려움은 없었습니다. 단지 앞으로 오일교체할때 언더카울도 무조건 탈거해야하는 부분이 번거롭기는 하겠네요.
배송은 주말껴서 딱 일주일 걸렸습니다. 재고가 있는 제품이라면 4~5일이면 도착 하는것으로 보입니다. 앞으로 이 브랜드 제품도 눈여겨서 보게 될 것 같습니다.----------------------------------------------------------It is a product that I bought the most because I liked the design while looking for an undercover that wrapped up to the back. There was some, but fortunately, the conclusion is very satisfying. Sensing the exhaust pipes of genuine, even though it is a carbon -made carbon undercover of handmade, the fitting is good without any problems. Washer in the state of the vehicle should be cleared to some extent, but there was no difficulty in installing. It's cumbersome to remove the undercarls when you replace the oil. Delivery took just a week on weekends. If you have stocks, it seems to arrive in 4-5 days. I think this brand product will be noticed in the future.Powered by Google TranslatorView Detail
This is changed the look of my bike so much. Instructions are easy and it comes unpainted. I ended up painting (rattle can) gloss black and it worked out. No issues...and works with after market exhaust systems as well.View Detail
Wanted it for a bit of trackday work. Makes the bike unrideable. Resonates left an right. The faster you go the more movement you get.If you like your screen moving an inch left to right in increasing frequency, which causes your helmet to do the same thing than this screen is for you. 2mm is to thin.Ok below 100kmh.View Detail
I painted it a low gloss black. I installed the bracket without the provided spacers. This pulled the bracket in 12mm so touching it with my right heal isn't as annoying when my toes are one the peg. This bracket does send a minor vibration through to the handle bars as the muffler moves about on rough roads.View Detail
Fits: KAWASAKI ZZR 600 93-00 Typ ZX600E, KAWASAKI ZXR 400 91- Typ ZX400L, KAWASAKI ZX-9R 98-99 Typ ZX900C/D, KAWASAKI ZR 7 99- Typ ZR750F, KAWASAKI Z750 S 04-06 Typ ZR750J
Tried the Oem slipon with the Akro headers, it was nice but too loud for the neighbours. Tried the Akro slipon but it turned the exhaust rasp into a phttt, phht and didn't like the look. Yoshimura tones down the rasp 30% from oem under 3-4k but then releases that glorious Z9 aura from then on. I like the neo retro look and have found it to be robust and easy to clean. This one is made in japan, can't comment on US version.Another Yoshi fan here.View Detail
Couldn't decide if I needed it to hide the slip-on nut and bolt but am happy with the purchase. Does stop the heat from the heal of my boot and looks like a piece of jewelry on the z900rs with a yoshimura R77 slip-on and Akropovic headers.View Detail
?
일본
최대 쇼핑몰
전용 쿠폰,
세일
빠르고, 안정적인
배송