I am very impressed with the incredibly fast service! The Daytona handlebar set made in from Japan to Albuquerque, New Mexico in just SEVEN DAYS!!The handlebar set is precision made from high quality materials and stainless steel hardware, faultlessly anodized. Installation was straight forward. I have just one concern about the finished job: the position of the bars cause a very tight bend in the clutch cable at the lever. I believe the cable must have a friction free lining, as it still works fine.Overall, I'm very satisfied with the Daytona kit, because it solves the ergonomic issues I had with the stock bars. Many thanks to Webike for your superior service!!
Very easy to install with only 8mm socket and philips screwdriver. Hardest part was getting the factory grip off on the left side. Bars look great and are not too much more aggressive over stock. Worked great with a bar end mirror from CRG. Very good quality and I like the fact that holes were drilled for all controls straight out of the box. It made for a very easy bolt-on install.View Detail
I couldn't shake the feeling that the original Handlebar was uncomfortable, so I replaced it. It is very good for people whose body is used to 80's Motorcycle. Note, however, that the Handlebar will be low and far away. The hole for the Handlebar Switch did not fit properly, so I had to modify it.View Detail
Wider and higher then stock bars so is much more comfortable and also looks much better in my opinion.Fits well with +150mm longer cable sets and a 900mm brake hose. Electrical harness not need to be extended.View Detail
Very easy to install with only 8mm socket and philips screwdriver. Hardest part was getting the factory grip off on the left side. Bars look great and are not too much more aggressive over stock. Worked great with a bar end mirror from CRG. Very good quality and I like the fact that holes were drilled for all controls straight out of the box. It made for a very easy bolt-on install.View Detail
Fits: HONDA Ape 50 09 Frame No.] AC18-1000001 or later AC18, HONDA Ape 50 03 [Frame No.] AC16-1200001 to 1299999 AC16, HONDA Ape 50 04 Frame No.] AC16-1300001 or later AC16, HONDA Ape 50 06 [Frame No.] AC16-1400001 to 1499999 AC16, HONDA Ape 50 07 [Frame No.] AC16-1500001 to 1599999 AC16
사이즈 맞고 딱 좋네요 700m 이하를 찾다가 이거를 발견했는데 오히려 다른차종보다 ksr에 더 딱인거 같아요높이가 많이 낮아지기는 했지만 핸들 업 키트를 통해서 조금이라도 올라가니 운전할때 불편한점없이 조향이며 각도며 다 만족합니다.추후에 다른 차량에도 장착예정입니다.It's the right size and it's goodI found this while looking for less than 700m, but rather than other modelsI think it's more suitable for ksrAlthough the height has been lowered a lot, it is possible to raise it even a little through the handle-up kit.I am satisfied with the steering and angle without any inconvenience while driving.It will be installed on other vehicles in the future.View Detail
I mounted these on my tuning honda monkey baja. This one sits well in the hand and provides a positive seating position. The handlebars are not too narrow and not too wide. very goodView Detail
일본
최대 쇼핑몰
전용 쿠폰,
세일
빠르고, 안정적인
배송