I used it for cutting DID Non-seal, 530.
I do not skip the head of Pin. I could go on as it was.
I think that it can be used most among other cheap Cutter.
Durability was also good, there was not bending of the core.
Although the attached Handlebar comes out soon, it is hard to use, but there is no problem because the shape that Spanner can use.
The Grip part is something like a decoration, but I can not apply much power, but better than nothing.
The press-fitting of the part on the receiving side of Pin was sweet.
Accuracy is somewhat uneasy but I think that it is good tool in general, durability, excellent tool for Cost performance.
I used it 3 times and there are no signs of breaking at the moment, but I will buy it even if it gets broken.
I was forced to adjust it with Hammer and Punch, but I decided to buy a special tool.
But I don't know a lot of things because I haven't exchanged chains yet.
However, the product is heavier than I expected, and the price seems to be reasonable and fragile (the texture of the Gold genus is not good enough for it to take a lot of force, and it looks like it will bend and shatter).
Also, there is no Construction Manual, so you will need to study it before using it.View Detail
I used it for 420Chain, but the second time I used it, the Screw became stupid
It's expensive for a consumable tool Should I have used Grinder or Leutor to shave off the head of the Pin, even as an auxiliary?
I'd like to choose a better one next time and make sure I don't break it the same way I thinkView Detail
It's still unopened, but it looks good
It's still unopened, but it looks good
It's still unopened, but it looks good
It's still unopened, but it looks good
It's still unopened, but it looks good
It's still unopened, but it looks good
It's still unopened, but it looks good
It's still unopened, but it looks good
It's still unopened, but it looks good
It's still unopened, but it looks good
View Detail
I used it for the 520Size SealChain, but
It seems to be unsuitable because it is a little wider than the non-seal chain
I used Grinder to skip the head of the LINKPin, but
When it is bitten into the Chain, the width is limited and the pin thread is shallow
The screw thread was shattered and the pin itself started to tilt and broke in one shot
The 520 non-seal and lower chains may be usedView Detail
Cut the 520 MotocrossCain?
I also used Pin's head without cutting it, I only need the power at the beginning, but if I just dropped out for the first time I was able to escape the throat afterwards?
I tried with the attached stick, but can you use it without problems?View Detail
일본
최대 쇼핑몰
전용 쿠폰,
세일
빠르고, 안정적인
배송