- Purchased this one because it is slightly cheaper than OEM. I don't think there is much of a problem. I know many people reuse them because they tighten so tightly, but considering the significance of...자세히보기
- I am purchasing this because I need it to replace the Slip-on Silencer.The quality is fine and it prevents exhaust leaks well, but it is a consumable item and I would like it to be a little less expen...자세히보기
- [How is it used?I used it to replace the YOSHIMURAExhaust System on my WR155.How was your experience with it?It is usable without leaks of exhaust Gas.How did it compare to other products?I have never...자세히보기
- Used to replace the Exhaust System on a 2001 D Tracker with an external Slip-on Silencer.OEM Parts No. 11061-1055For late D Tracker and KLX.The size of the Gasket is different from the previous year's...자세히보기
- I bought a used SKYWAVE (CJ45A) at a flea market in August 2023, and I felt that the sound was too loud for an OEM exhaust system. I was surprised that the sound became quieter after replacing the exh...자세히보기
- At first I thought it was defective because it was too tight, but when I pushed it in slowly and carefully, paying attention to the angle of the frame, it went in like a hammer. It may be a bit expens...자세히보기
- [How is it used?Replaced during installation on an XJR400R Slip-on Silencer.I chose this KITACO product because it is a consumable and the OEM price was too high.How was your experience with it?The Si...자세히보기
- SizeExactly and working well, no failures and no MOLLET.자세히보기
- [How is it used?New CB1100 Exhaust System from OEM to MORIWAKISlip-on SilencerMegaphone Exhaust.How was your experience with it?It was shorter in length than the OEM Gasket, but has not leaked for ove...자세히보기
- Arrived 3 days after ordering. The O2 Sensor was left in place, the exhaust system was installed, 3 bolts were removed, and the Gasket was installed. It was as if it was a new car (I don't know!). It ...자세히보기
- I bought this to replace my Slip-on Silencer and there are no exhaust leaks, no doubt about it.자세히보기
- Required Replacement Items when purchasing and replacing Slip-on Silencer.In most cases, the joint gasket that connects the silencer part to the exhaust pipe part will stick when heated and cannot be ...자세히보기
- [How is it used?Purchased to eliminate the gap between the middle pipe and exhaust pipe in order to install a Slip-on Silencer.How was your experience with it?Exhaust pipe and Gasket are perfectly siz...자세히보기
- [How is it used?Used on OEM Exhaust pipe and Silencer joint of MainMotorcycle's XJR1300C that had been inspected.The Exhaust System itself is the same as the normal XJR1300, so Gasket could be used no...자세히보기
- Purchased to install YOSHIMURA's Slip-on Silencer.Since the vehicle was still new, I thought about reusing the one that had been installed, but I replaced it with a new one just to be safe.It was thic...자세히보기
- The quality is good enough even if it is not OEM자세히보기
일본
최대 쇼핑몰
전용 쿠폰,
세일
빠르고, 안정적인
배송