L 크랭크케이스 커버 알텍 볼트

Nice quality and reasonably priced item. I highly recommend this. It will work well with my Hunter Cub. I hope you drive safely and have an enjoyable motor life.

First, I tightened it with the specified Torque8N/m and it broke.
The anodized part of the screw was uneven and I am not sure if this was the cause of the breakage or not. I am not sure if this was the cause of the breakage, since all the screws were similar.
Quantity:2pcs broken and only 4 replaced 7~7.5N/m Bolt length 20mm is quantity:There are 2pcs left over.
For Mr. Mukawa, it was a rare dud.
I had a Engine slider, so I thought I could use 6 screws, but I broke them, so I had no choice.
Incidentally, the Right Side is not usable because it is 40mm compared to the NORMAL 35mm. So, I purchased an additional LeftBolt, but the same thing happened here. It is a pity.
Quantity:Pair (for Left and Right) We use four of each only where we can see them.
I would not recommend a 92 Grom, but a type 2 Grom might be a good choice.
It is made of aluminum, so it is very light.

German flag in RedBlackGold (oh, BlackRedGold in that order) This is my Grom during the dress-up at Concept I'm changing it to Gold Glow parts as much as I can, but I feel that I've finally reached the peak I am amazed that Mr. Takegawa did well to make the Case of Engine Color Anodized Aluminum to the Steel Bolt that's stopping It's a custom that changes to aluminum bolts Naturally, it doesn't affect the function This is just fashion....it might be a little light, but the durability is a little worried It may be a little bit light, but the durability is not so strong
This report is for Left Side. in fact, there is a separate report for Engine Right Side I'm writing a separate report on that one, too They're the same thing, right? I thought at first, but the length of the bolts are actually different There are two types of bolts for Left Side, six 35mm long and four 25mm long It comes packaged and is used for different parts For securing the plastic Sprocket Cover, it stops through the Washer Quantity:2pc. SetWasher was also included
The Instruction Manual states "We recommend replacing the Gasket but instead of removing everything and then replacing it with this Aluminum Bolt, 1 pc I did not open the Case because I replaced it one by one Since it is only to remove the Screw and put it back on, it is naturally difficult to work There is no The tightening torque is 8Nm should not be At first, I wasn't sure where I was going to change it, but what a difference it made to Driven Sprocket's The Bolt on the inside of which Cover is removed is also to be replaced It is not visible when Cover is done, and it may not be necessary to put it on if Cover is put back (I did change one) And since we've already changed 2 Bolts to install the OVER Slider That part remains intact That left 1 pc each of 25 and 35mm
See the last photo for the condition after installation As you can see, it is Shiningly Of course, in terms of area, Engine's Camshaft Cover is much larger than Engine's Camshaft Cover Shiningly, the gold color has a very strong presence even on Spot It feels like it's being used Whether you think it's vulgar or beautiful depends on your sensitivity I think it's beautiful Electric lights and Lame can be a bit vulgar, but this one is gorgeous and I like it Grom doesn't look scary no matter what you do, it's just small and cute! Hey, it's a good idea