미터스크린 프로텍티브 필름

두장이 한셋트로 들어있어서 처음 장착할 당시에 작은 실수로 인해 장착에 실패하고, 다행히 여유분으로 다시 시도하여 성공했습니다. 중성세제가 조금 섞인 물을 뿌려서 충분히 먼지등을 씻어내고 장착하였습니다. 햇볓에 의한 반사는 막아주지 못하여 시간이나 방향에 따라 햇볕이 반사되어 보기 힘든건 어쩔 수 없습니다만, 피팅이 잘 맞고 자잘한 먼지등으로 인한 상처로부터 잘 보호가 될거 같아 마음에 들었습니다.

I bought this product because I didn't want my meter to get scratched, so I bought the Instruction Manual, AlcoholPaper for degreasing, Quantity:1 Set of 2pcs., The spatula is enough to remove the bubbles. The CT110 HUNTER CUB Meter Bulb surface is quite difficult to remove the air bubbles.

The Film which became the base of Reverse side did not come off easily no matter how carefully and carefully I did. It is not peeled off at first by turning the Seal which is attached. After all, it wakes up with a nail and it becomes a thing to peel off, and the edge of BodyFilm is damaged inevitably.
Also, the CT125 Meter is a curved surface, so the degree of difficulty is quite high, and even if I discount my clumsiness, I couldn't paste it satisfactorily with the Film which damaged the edge. In the end, I threw away both of them because the glue was left when I removed them from the Meter, and I had to damage the Meter to remove it.
We recommend that you leave the work to a shop that knows how to do it, but even a PRO may not be able to remove the mount film well.

[How is it used?
daily use

Was the one you received as per Image?
As per Image, 2pcs, thin feeling of Screen Protection Seal for smartphone.

How was your experience with it?
CT110 HUNTER CUB Meter is difficult to paste because of the curved surface, I was not able to remove air bubbles well!

[Points to note]
Difficult to apply, especially to remove air bubbles, I was left with a few bubbles!

The Meterassy of the CT125 CT110 HUNTER CUB has a convex spherical structure of resin, which is easier to scratch than you think!
So I Ordered this product!

As a matter of fact, it's only after it's scratched that I'm able to remove the scratches at the same time ω

I ordered a low cost headlight polish with Linley solvent, polished it twice, and repeated finishing with Micro fiber, and it recovered a reasonably clean feeling.

From there, as per the Manual, degreasing cleaning> temporary fasteningSeal using three temporary fastening, since there is no mist spray, Self sake splashω
I filled it with water, scraped out the air bubbles with the included spatula, and somehow
I'm glad I didn't make a mistake and fall into the trap of having to use a second one ω

The manual is very helpful, and the work is not so difficult if you follow the steps and do it properly.
I think it's Level for 15 minutes of labor.

The CT110 HUNTER CUB is a digital meter, so it's hard to understand intuitively, so it's important to keep the meter screen visible.
I think it's not a bad idea to use a protective film to prevent scratches before they happen.