■ 상품의 특징
단 10초만에 걸 수 있다.
·오렌지 손잡이와 지퍼로 커버의 앞뒤를 알기 쉽다.
·커버 안쪽에 내열 온도 약 360도의 잘 녹지 않는 면 소재를 사용. 엔진을 식히는 시간을 기다리지 않아도 된다.
·1번 짜면 조절이 필요 없는 스소 조리개 기능
·바람이 튀는 방지 ·커버 보관이 편리한 벨트 포함→공간 절약으로 커버를 보관할 수 있다! 보관시 커버를 더럽히지 않는다!
■덮어 체감! 10초 만에 오토바이에 걸 수 있는 오토바이 커버
오렌지 손잡이와 뒷면 지퍼를 가지고 오토바이를 앞으로 살짝 걸어주면 된다.
쓱 뒤로 당기기만 하면 커버를 제대로 걸 수 있으니까, 팍팍 펼쳐서 걸 필요 없음!!
쓸데없는 동작이 없으니까 10초만에 걸 수 있어요.
원래의 커버는 사각사각에 둔 상태라면, 커버의 앞뒤를 몰라 일부러 펼칠 필요가....
이 오토바이 커버라면 실버 원단부터 잘 보이는 오렌지 손잡이와 지퍼로 커버를 펼칠 필요 없음!
한눈에 앞뒤를 알 수 있습니다.
사실 머플러보다 더 뜨거운 익파이 (엑저스트 파이프) 가 닿아도 괜찮도록 내열 온도 약 360도의 면 원단을 사용.
타사의 내열 바이크 커버는 머플러 부분이 닿는 부분을 중점으로 비스듬히 면원단이 사용되고 있는데 반해, 이 바이크 커버는 고온이 되는 부분을 탁 덮어 커버가 녹아 붙는 것을 방지합니다.
바람 부는 것을 방지하기 위해 센터 버클이 달려 있는 오토바이 커버도 많을 것이다.
하지만 엔진부분에 달라붙어 녹거나 면원단이 붙어있지 않은 부분에 고온부가 닿아 커버가 녹아 버리거나....
무엇보다 외상이 너무 귀찮아!
그런 시간을 줄이기 위해 한 번 짜면 더 이상 느슨하게 만들 필요가 없는 스소 조리개 기능을 채택.
기존 바이크 커버의 스소 조리개 기능은 부착할 때마다 느슨하게 풀어야 했습니다
이 오토바이 커버라면, 뒷면 지퍼가 있기 때문에 쇠톱을 짠 상태에서도 커버를 벗길 수 있습니다.
앞뒤 잠금홀 모두 잠그는 것은 귀찮다...라고 하는 경우는 어느 한쪽의 잠금홀에 벨트를 매면 제대로 바람 부는 것을 방지할 수 있습니다.
오토바이 커버는 크기 때문에 보관 장소에 곤란해하는 사람도 많을 거야.
아파트나 아파트라면 자기 방 베란다나 공용 주차장의 지면 정도 밖에 둘 장소가 없다는 것도....
하지만 지면에 두면 모래나 먼지로 더러워져 다음에 커버를 사용할 때, 오토바이에 더러워져서 커버의 의미가 없어!
부속 벨트로 정리하면 공간 절약되고 커버가 더러워지지 않는 곳에 보관할 수 있습니다.
젖은 상태의 커버도 빨랫줄에 걸치기 때문에 단단히 말릴 수 있습니다.
이외에도, 커버 내 땀 차는 것을 방지하는 통기구, 오토바이 방범 대책으로 직경 40mm의 잠금 홀, 자외선 90% 이상 차단!
발수 가공 완료 300D의 두꺼운 원단 등 특징이 가득!
■ 손질 방법
·원단의 발수효과를 지키기 위해 세탁기 사용 및 비벼세탁은 피해주십시오.
· 얼룩은 미지근한 물 또는 물로 씻어내거나 희석한 중성세제를 적신 천을 꽉 짜서 닦아내 주세요.
·커버에 쓰레기나 얼룩이 묻은 채로 장시간 방치하면, 발수 효과가 손상됩니다.
■Product Features
・It only takes 10 seconds to call
・Orange handles and zipper make it easy to see the front and back of the cover
・The inside of the cover is made of a heat-resistant cotton material with a temperature of about 360 degrees Celsius.No need to wait for the engine to cool down
・Once squeezed, the sole squeezing function does not require adjustment
・With a belt for wind-skipping prevention and cover storage → space-saving cover storage!No more soiling the cover when storing it!
■ Put it on and feel it!Bike cover that can be put on a bike in 10 seconds
Just take the orange handle and rear zipper and quickly put it over the front of the bike, then just pull it on.
Just pull it backwards to apply the cover securely, so there's no need to spread it out like a flap!!!
It can be applied in 10 seconds with no wasted motion.
When the cover is placed in a crumpled position, it is difficult to tell the front and back of the cover, and it is necessary to spread it out.
With this bike cover, you don't have to unfold the cover, with orange handles and zippers that are easily visible through the silver fabric!
You can tell the front and back at a glance.
Cotton fabric with a heat resistance temperature of approximately 360 degrees is used so that the exhaust pipe, which is actually hotter than the exhaust, can come in contact with it.
While other companies' heat-resistant motorcycle covers use cotton fabric at an angle, focusing on the area where the exhaust hits, this motorcycle cover covers the area that gets hot and prevents the cover from melting and sticking to the exhaust.
Many bike covers should have a center buckle to prevent wind skipping.
However, the cover may melt by sticking to the engine parts, or by touching the hot parts where the cotton fabric is not attached....
Above all, it's very cumbersome to put on and take off!
In order to shorten the time required for this, a function is adopted that allows the bottom to taper so that once it is tightened, there is no need to loosen it again.
With the conventional thread-squeeze function of the bike cover, it is necessary to loosen the cover each time it is put on or taken off.
With this bike cover, the rear zipper allows the cover to be attached and detached even with the soffit closed.
It's a hassle to put locks on both the front and rear lock holes... If this is the case, you can attach a belt to one of the locking holes to prevent the wind from blowing off.
Bike covers are large, so many people have trouble finding a place to store them.
In an apartment or condominium, the only place to put a bicycle is on the balcony of your room or on the ground of a shared bicycle parking lot....
But if you put it on the ground, it gets so dirty with sand and dust that the next time you use the cover, the dirt gets on the bike and the cover is useless!
The attached belt can be used to put them together to save space and keep them in a place where the cover will not get dirty.
The cover can be hung on a clothesline when wet, so it can be hung to dry properly.
Other features include air vents to prevent steam inside the cover, a 40mm diameter lock hole for motorcycle security, and over 90% UV protection!
It has many features, including a water-repellent 300D thick fabric!
■How to care for the product
・To protect the water-repellent effect of the fabric, please do not use a washing machine or wring it out.
・For stains, rinse with lukewarm water or water, or wipe with a cloth dampened with diluted neutral detergent and squeeze tightly.
・If the cover is left with dust or dirt on it for a long period of time, the water repellent effect will be lost.